Shovelhead Squish Pipe Headpipe Sets For 1966-1969 Rigid Frames

Description

1-3/4″ Squish Pipe Headpipe SetsFor 1966 – 1969 Rigid Shovelheads
Choose from two Shotgun sets, two Upsweep sets, or a 2-into-1 headpipe set with front inside-the-frame squish pipes, for your early Shovelhead.

3-PIECE SHOTGUN HEADPIPES
For rigid frames with kickstart ONLY. Heat shields for the rear Shotgun pipes are recommended. Use Paughco #725D clamps to install.

713B Headpipes ONLY for use with extensionsor mufflers
713D Side-by-side headpipes ONLY for use with extensions or mufflers
411BR Rear heat shield for Paughco #s 713B and 713D pipe sets (not shown)

3-PIECE UPSWEEP HEADPIPES
For rigid frames ONLY. Heat shields for the rear pipes are recommended. Use Paughco #725D clamps to install.

716B Headpipes ONLY for use with extensions or mufflers (fits kickstart only) shownbelow on bike
716BE Same as Paughco #716B except the rear pipe fits with an electric start wraparoundoil tank
415BR Rear heat shield for Paughco #716B pipe set (shown below on bike)

3-PIECE 2-INTO-1 HEADPIPES
For 19661969 rigid and swingarm frames. Also fits 1970up cone alternator engines in early frames. Use Paughco #725D clamps to install.

713C Headpipes ONLY for use with an extensionor muffler
413CR Fits Paughco #713C rear pipe when installed on bikes with mechanical or hydraulic brakes (not shown)

Special Notes:
1) Straight pipes are not recommended for use on the street.
2) See page 247 for P-clamps and frame rail clamps to install these pipe sets.
3) See pages 349-353 for photos of the heat shields for these pipe sets.