Panhead Upsweep S Pipe Systems For 1948 – 1957 Rigid Frames

Description

1-3/4″ Panhead Upsweep S Pipe Systems For 1948 – 1957 Rigid Frames
Choose from Upsweep or over-the-transmission rear pipes. All of these pipe sets are intended for use on kickstart engines in rigid frames ONLY.

3-PIECE UPSWEEP HEADPIPES

715B Headpipes ONLY for use with extensions or mufflers (use Paughco #s 725B and 725Dclamps to install)
415BR Rear heat shield for Paughco #715B pipe set(not shown)

3-PIECE OVER-THE-TRANSMISSION UPSWEEP PIPE SETS
The rear pipes turn up to follow the bottom frame rail, and will clear an electric start wrap-around oil tank. Paughco #718-9 mounting hardware is included with Paughco #s 715BA, 715BS and 715BST pipe sets.

715BA Goose Cut drag pipes (shown belowon bike)
715BS Slash Cut drag pipes (not shown)
715BST Straight Cut drag pipes (not shown)
715B1 Headpipes ONLY for use with extensions or mufflers (use Paughco #s 725B and 725Dclamps to install)
718-9 Replacement hanger kit for Paughco #s 715BA, 715BS, 715BST pipe sets
414B1R Rear heat shield for Paughco #s 715BA, 715BS, 715BST and 715B1 pipe sets(shown below on bike)

Special Notes:
1) Drag pipes are not recommended for use on the street.
2) See page 247 for P-clamps and frame rail clamps to install these pipe sets.