AAE OMP KNOB 4-5-6

Description

OMP Knob4-5-6

Introducing the latest addition in AAEs lineup of precision fletching jig knob upgrades! TheOMP fletching knobby AAE was engineered in the footprint of AAEs ever-popularBitz knobto have the same accuracy and smooth feel. Designed to complement theOMP Phoenix fletchingjig by adding a precise and indexable way to fletch. Whether you need to replace a single vane with accuracy or add indexability when building arrows with glue on nocks theAAE OMP knobis the only fletching knob for the job. With etched timing marks installed on the face for repeatability, theAAE OMP knobstands out as the arrow builders choice.

Available not only in the standard 3 fletch 120 degrees, 4 fletch 90 degrees and 4 fletch 105 X 75 degrees knob, but also in 4 fletch 90 degrees 5 fletch 72 degrees and 6 fletch 60 degrees knob.

Both the Standard 3-4 and 4-5-6 knobs come with astandard nock receiver forkthat securely hold almost any standard nock on the market with 3 other interchangeable nock forks available (sold separately) for most every arrow build.

Installation instructions-

To install your new AAE OMP knob start by loosening the three 1/16 hex screws that allow you to select vane orientation to the point where there is not spring tension on the screw. Then below the three set screws is a 5/32 hex bolt with a locating pin, remove this screw all the way and set in a safe place. Then without removing the old knob rotate the entire fletching jig upside down and remove the old knob slowly as to not lose your indexing balls and springs. Install the new AAE OMP knob and then rotate right side up. Replace the 5/32 hex screw with locating pin. Before tightening all the way ensure your new knob is correctly located so the pin lines up with the slot in the knob so as not to damage it. Return to the 1/16 hex set screw with your selected vane orientation and tighten until you can feel resistance when turning the knob in the jig, you feel the indexing ball lock firmly into the indexing dimples in the knob. Do not overtighten these screws as you will damage the knob.